HOME                          About Us                         Products                  Support                       

Contact Us

 
   - A   + A
 www.ptasia.info
  Search   

seting your cap sealer

Follow these steps to insure proper sealing power.
1.Insure sealing head is aligned correctly. [Details]
2.Set conveyor for the production line speed.
3.Insure land of the bottle top (seal point on bottle) is reasonably free of burns, seams, etc.
4.Insure caps are properly torqued, applying proper force to seat the seals . Consult the cap manufacturer for proper settings. A rule of thumb is to use 1/2 the liner diameter (in millimeters) as the torque setting in inch-pounds. Example: a 38mm liner would require 19 inch-pounds of torque. See our suggested cap torque guide below.
5.Start at minimum power (typically 25%). Run a single container underneath the sealing coil. Check the bottle for a seal. Did it seal at all? If it partially sealed, use a new bottle and go to Step 6. If it didn’t, repeat the test with a 10% power increase until the container seals.
6.Refine the setting with 1-2% power adjustments until the desired seal is achieved.
7.Position and run a tightly grouped number of containers in-line which completely occupies the full length underneath the sealing head. This will test the power load requirements for a maximum loading situation using these containers. Verify the power output meter reads a constant value when performing this test.
8.Record power level settings (meter reading), line speed, and cap type for future reference. Do this for the various types of caps and containers used.


 




All of Enercon induction cap sealers,
including the Super Seal pictured
above, are easy to setup and adjust
to achieve your desired seal.

Suggested Cap Application Torque
Closure Diameter (mm)
  Torque(in-lbs)

15
18
20
22
24
28
33
38
43
48
53
58
63
70
83
89
100
110
120
  6-9
7-10
8-12
9-14
10-16
12-18
15-25
17-26
18-27
19-30
21-36
23-48
25-43
28-50
40-60
45-65
50-70
52-73
55-75


Cap Inspection Systems
eJector™
Flashing Light
Mobile Cart
Motion-Foil Detection
Quick-Set Adjustable
Remote Control
Variable Sealing Control
All-in-One Head
Flat Sealing Heads
Tunnel Sealing Head
involving Floratine Products
Tropicana’s Clear PET
Bryson Industries, Inc.,
BBQ sauce/salad
AccuDial spins children
Sam’s Club
HOME                          About Us                         Products                  Support                       

Contact Us

 
    ©Copyright 2002-2018 All rights reserved.
the GROUP of PT Asia
998 Moo 3, Samrong Nua, Muang, Samutprakarn 10270 Thailand
Tel : +66 (0)2 759-3605-12 Fax: +66 (0)2 759-3569
Email : support@ptasia.info